EPOXY FILLER 1500 

Epifanes Epoxy Filler 1500

A very strong two-component light-weight filler based on epoxy resins. Chemical and water resistant, shrink-free and low odour. Can fill up to 1.5 cm in one single application. Prior to use, stir each component separately and then thoroughly together until colour is uniform. Do not use under 12°C. Best sandable properties are between 24 and 48 hours.

Application:
Fiberglass - Steel - Wood - aluminium: in two-component epoxy systems above and below the waterline. Smaller repairs may also be top coated with one-component primers/ topcoats. Larger repair areas should always be top coated with two-component Poly-urethane. May be followed by a one-component finish if desired.

Filled areas must be well degreased with Epifanes Spray thinner for Paint and Varnish. This will prevent clogging of grease in the sandpaper and will ensure a better bonding. Follow by sanding with 120.

EPOXY FINISHING FILLER 

Epifanes Epoxy Finishing Filler

A strong two-component finishing filler on epoxy resins. Very fi ne and shrink free. Provides a very smooth surface. Apply in thin layers only (max. 1 mm). Prior to use, stir each component separately and then thoroughly together until colour is uniform. Do not use under 60°F./12°C. Best sandable properties are between 24 and 48 hours.

Application:
Fiberglass - Steel - Wood - aluminium: a fine epoxy finishing filler for use on Epifanes Epoxy Filler 1500 in two-component paint systems above and if needed below the waterline. If top coated above the waterline with a one-component finish, first apply one coat Epifanes Poly-urethane Yacht Coating or Poly-urethane Primer.

Notes:
Filled areas must be well degreased with Epifanes Spray thinner for Paint and Varnish. This will prevent clogging of grease in the sandpaper and will ensure a better bonding. Follow by sanding with 120.

FIBREGLASS FILLER  

Epifanes Fiberglass Filler

A fast drying, two-component filler suitable for small repairs on steel and fiberglass. Can be
applied in thick layers. Before use, mix well with 2-4 % of the reactor from the tube. Recoatable with all Epifanes one and two component products.

Application:
Fiberglass: repair and filling of small irregularities above the waterline. Steel: Small repairs in paint systems above the waterline.

 

 

Remarks:
After cure, immediately sand and overcoat this filler with a 15-20% thinned sealer coat. The sealer coat prevents moisture from entering the filler.

COMBI FILLER 

Epifanes Combi Filler

A traditional one-component knifing filler based on alkyd resins. Suitable for leveling of small
irregularities in one-component paint systems for wood or steel above the waterline. Apply in thin layers only (max. 1 mm)

Application:
Repair and filling of small irregularities in one-component paint systems on wood and steel above the waterline.

 

Notes:
Apply between primer coats or prior to the first finishing topcoat.

© 2020 Jackson Marine Ltd. All Rights Reserved. Proudly created with Wix.com

  • Facebook
  • Twitter
  • Instagram